AzNET Broadband Quickstart for Windows 2000
For printable MS Word version click here
- Ensure you have an Ethernet Network Interface Card (NIC) installed and correctly configured in your computer.
- Plug one end of a CAT 5 cable into your computer's NIC and the other end into the LAN interface on the broadband connection device (DNS modem, etc).
- Open the property settings for your computer's LAN interface by doing the following:
- Click Start - Settings - Network and Dialup Connections
- Right click the Local Area Connection for the interface you connected to the transceiver.
- Select Properties
- Select Internet Protocol (TCP/IP) then click the Properties button.
- Select "Use the following IP address"
- Specify the IP address, Subnet mask and Default gateway for your machine (included in your install package)
- Select "Use the following DNS server addresses"
- Specify the primary and alternate DNS server addresses
- Primary: 207.167.67.1
- Secondary: 207.167.96.1
- Click OK until your back to the desktop.
- Finished
To connect multiple computers:
- You will need to connect an Ethernet hub or switch into the broadband connection device. Follow the instructions included with your hub or switch for connecting to a router. In some instances, a cross-over Ethernet cable may be required. However, some devices have built-in cross-over ports than can be used in lieu of cross-over cables.
- Follow the steps for connecting one computer above, skipping step 2. Plug one end of your computer into an available port on the hub or switch.
- Continue the instructions above, beginning at step 3.
Return to the AzNET Setup Pages
